3D printing Rakka
I just downloaded the asset pack for Vol1 today and ran a test print of the Klum-alien.
1) to OATS: I think version files that aren't hollowed out would be good, cause during cleaning, I get a lot of isopropanol trapped inside. (Had to drill asecond hole in the base to clear the vacuum so the liquid could escape). It also makes the entire model more fragile and less functional for post-print modding.
2) to FANS: Has anyone tried a rigged version and done some other cool poses? I think it would be fun to not have an over-the-top "hero" pose but rather try to print poses more along the line of the two "guards" walking behind the propaganda shouter.
(This post should probably have been in the steam DLC section)
Sign in or register to add a comment.
Add a Comment
Oats Studios Forum
Cooking With Bill
Terms of Service
Useful Hints and Tips
Created with PlushForums
© 2017 Oats Studios